Delta GR150 Manual de instrucciones

INSTRUCTION MANUAL6" Bench Grinder(Model GR100 and GR150)PART NO. A13267 - 07-12-05 Rev. ACopyright © 2005 Delta MachineryESPAÑOL: PÁGINA 15To le

10Fig. 72. Align the holes in the eye shield with the holes in the spark guard and place the eye shield bushing (A) Fig. 7, inbetween the space in the

11FLEXIBLE LAMP (GR150 ONLY)The flexible lamp operates independently of the grinder.To turn the lamp on and off, rotate switch (A) Fig. 11.WARNING: To

12DRESSING A GRINDING WHEELWhen dressing a grinding wheel use a suitable siliconcarbide stick type dresser, as shown in Fig. 15. Bring thedresser forw

13MAINTENANCEREPLACEMENT PARTSWhen servicing use only identical replacement parts. Checkthe parts list included for more information. Parts lists cana

14Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine

Delta Machinery4825 Highway 45 NorthJackson, TN 383051-800-223-7278www.deltamachinery.com

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5ADDITIONAL SPECIFIC SAFETY RULES1. DO NOT OPERATE THIS MACHINE until it iscompletely assembled and installed according to theinstructions. A machine

6Fig. A Fig. BGROUNDED OUTLET BOXCURRENTCARRYINGPRONGSGROUNDING BLADEIS LONGEST OF THE 3 BLADESGROUNDED OUTLET BOXGROUNDINGMEANSADAPTERPOWER CONNECTIO

7EXTENSION CORDSUse proper extension cords. Make sureyour extension cord is in good condition and is a 3-wireextension cord which has a 3-prong ground

8Fig.11. Grinder (GR150 pictured)2. Wrench3. Eye shield (2)4. Eye shield knob (2)5. Eye shield bushing (2)6. Left side spark guard7. Right side spark

9Fig. 3TOOL RESTS1. Assemble the v-grooved tool rest (A) Fig. 3, to the inside of the right wheel guard using two 3/4" flat washers (C),and two 5