Delta AP300 Manual de instrucciones

INSTRUCTION MANUALPortable Single-StageDust Collector(Model AP300)PART NO. 905588 - 05-13-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 17To learn

10VACUUM HOSE TODUST COLLECTOR1. Place the intake cap holder (D) on the dust collectoras shown in Fig. 15. NOTE: DO NOT COVER THEINTAKE PORT WITH THE

11Fig. 17Fig. 18Fig. 19Fig. 203. Place the remaining hose clamp (A) Fig. 17, aroundthe other end of hose (B), slide hose (B) onto intakefunnel (C), an

12OPERATING CONTROLS & ADJUSTMENTSWARNING: FOR OPERATOR SAFETY, MAKE CERTAINTHE DUST INTAKE PORT IS COVERED WITH THE HOSEBEFORE OPERATING THE MACH

13OPERATIONSThis versatile dust collector is light, compact and caneasily be transported for use in and out of the workshop.This dust collector can be

TRANSPORTATION ANDSTORAGE1. The dust collector features a convenient carryinghandle with rubber grip (A) Fig. 29, which allows the unitto be carried e

15NOTES

16Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

ADDITIONAL SAFETY RULES FORDUST COLLECTORS3WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6DUST COLLECTOR PARTSFig. 21. Dust collector2. Hose3. Dust bag4. Exhaust flange5. Exhaust flange gasket6. Intake funnel7. Intake support angle brace8.

7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE TOOL TO THE POWER SOURCE UNTIL THEMACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAN

8DUST PORT TUBE ANDCONNECTOR TO DUSTCOLLECTOR BODY1. Place tube clamp (A) Fig. 7 on the lower supporttube holder (B).2. Insert the lower tube support

94. Align the two holes in the intake support angle brace(A) Fig. 10 with the two holes in the intake funnel (B).5. Fasten the intake support angle br