Delta 36-444 Manual de instrucciones descargar pdf (Pagina 20)

Fig. 53

Fig. 54

Fig. 55

Fig. 56

CHANGING THE

SAW BLADE

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

1. NOTE: Two 7/8″ wrenches are supplied with the saw

for changing the saw blade: a box end wrench (A) Fig. 53,

and open end wrench (B).

2. Remove table insert (C) Fig. 53, and raise saw blade

to its maximum height.

3. Place the open end wrench (B) Fig. 54, on the flats of

the saw arbor to keep the arbor from turning, and using

wrench (A), turn the arbor nut toward the front of the saw.

Remove arbor nut, blade flange, and saw blade.

4. Assemble the new blade, making certain the teeth

point down at the front of the saw table, and assemble

outside blade flange and arbor nut. With wrench (B)

Fig. 54, on the flats of the arbor to keep it from turning,

tighten arbor nut by turning wrench (A) counterclockwise.

5. Replace table insert.

STORING THE MITER GAGE,

RIP FENCE, AND ARBOR

WRENCHES

1. When not in use, the miter gage (A) Fig. 55, can be

stored through the hole located at the front side of the

stand as shown.

2. The rip fence (B) Fig. 55, can be stored out-of-the-

way on the stamped ledges on the right side of the saw

stand.

3. Arbor wrenches (C) Fig. 56, can be stored on one of

the two notched legs.

DUST CHUTE

The saw stand support panel (D) Fig. 56, also serves as

a natural built-in dust chute. This dust chute (D) allows

the sawdust to escape out of the rear of the saw stand

and away from the work area.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Sin comentarios

Delta 36-444 Manual de instrucciones Pagina 20