Delta MS250 Manual del operador descargar pdf (Pagina 20)

Operator's Manual

Digital Group Setup

This procedure organizes the digital lines into groups, which correspond to buses. The

lines within a single group can be displayed individually, or collapsed into a Bus trace.

You can set up a total of two, distinct groups: Digital1 and Digital2 . Each group is

designated by its own Digital setup dialog.

Any lines from any lead bank can be combined into a single group, and individual lines

can be assigned to as many groups as you wish.

NOTE: While lines can be combined in any way, each lead bank can only have a single

logic setup, so be aware of that when choosing lines.

1. Go to Vertical > Digital 1 Setup to Display the Digital Setup dialog.

2. Open the dialog for the group you wish to configure (e.g., Digital1).

3. Check the box for each line to be added to the group. If a line is in a bank other than

the one displayed, touch the left or right arrow buttons until that bank is shown on

the dialog.

TIP: Use the All Lines Off and All Lines On buttons to quickly deselect/select lines.

NOTE: Along the bottom of the dialog is an indicator for each line in all the lead banks. As

add lines to the group, the indicator is checked, so you can always see all the lines

currently in the group. You can also use these checkboxes to select lines.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Sin comentarios

Delta MS250 Manual del operador Pagina 20