Delta BS150LS Manual de instrucciones descargar pdf (Pagina 10)

Fig.14

Fig.15

7. Fig. 14 shows the disassembled table tilt pinion

knob (N) , spring (O), and special screw (P), removed in

STEP 1.

8. Re-assemble the table tilt pinion knob (N) Fig. 15,

on the back of saw so that the teeth on the pinion knob

(N) engage the teeth on the trunnion (R). Fasten in place

with the special screw (P) and spring using the 4mm

wrench provided.

Fig. 13

4. Re-assemble the locking lever stud (G) Fig. 12

through the trunion slot (L) and tighten with the locking

lever handle (see inset).

5. Fig. 13 shows the table locking lever disassembled

(removed in STEP 1). Item (B) is a M10 flat washer, (G)

stud, (A) Locking Lever, (E) spring, (D) shoulder screw,

and (C) 4mm hex wrench.

6. Re-assemble the screw (D) Fig.13A and tighten using

4mm hex wrench privided.

Fig. 13A

Fig. 12

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

Sin comentarios

Delta BS150LS Manual de instrucciones Pagina 10