Delta 37-070 Manual de instrucciones

INSTRUCTION MANUAL6" Variable SpeedBench Jointer(Model 37-070)PART NO. 901609 (013)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 21To learn mor

10Fig. 13Fig. 14Fig. 15Fig. 16ASSEMBLINGCUTTERHEAD GUARD1. Thread the two 7/16" long socket button headscrews (A) Fig. 13, into the two threaded

11Fig. 22Fig. 21FASTENING JOINTER TO SUPPORTING SURFACEIf during operation, there is any tendency for the jointerto tip over, slide or walk on the sup

12VARIABLE SPEED CONTROLYour jointer is supplied with a variable speed controlknob (A) Fig. 23, that enables you to operate the machineat cutterhead s

13Fig. 26Fig. 27Fig. 28Fig. 293. The fence features adjustable positive stops at themost used fence positions of 90 degrees and 45 degreesto the right

14Fig. 30ADJUSTING KNIVESWhen it becomes necessary to adjust the knives due toreplacement or wear, proceed as follows:1. DISCONNECT THE TOOL FROM THE

15Fig. 36Fig. 35Fig. 34Fig. 33CORD STORAGEA cord storage bracket (A) Fig. 36, is provided on jointerbase for storage of the cord when machine is not i

16Fig. 39 Fig. 39APUSH BLOCKSA set of push blocks (A) Fig. 37, is supplied with yourjointer and should be used whenever possible tominimize all danger

17Fig. 42Fig. 41Fig. 40APLANING WARPED PIECESIf the wood to be planed is dished or warped, take light cuts until the surface is flat. Avoid forcing su

18MAINTENANCEBELT REPLACEMENTWhen it becomes necessary to replace the belt on yourjointer, proceed as follows:1. DISCONNECT THE TOOL FROM THE POWERSOU

Delta Building Trades and Home Shop MachineryTwo Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machin

2SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards in

20NOTES

The following are trademarks of PORTER-CABLE DELTA Corporation (Las siguientes son marcas registradas de PORTER-CABLE S.A.):BAMMER®, INNOVATION THAT W

31. DO NOT OPERATE the tool until it is completelyassembled and installed according to the instructions.2. IF YOU ARE NOT thoroughly familiar with the

4CONNECTING TOOL TO POWER SOURCEPOWER CONNECTIONSA separate electrical circuit should be used for your tools. This circuit should not be less than #12

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6DEFINITIONS OFJOINTING AND PLANING OPERATIONSFig. 2Fig. 31. JOINTING OPERATIONS – Jointing cuts or edgejointing are made to square an edge of a workp

7Fig. 41 - Jointer2 - Fence3 - Fence Sliding Bracket4 - Special Nut (for assembling Fence Sliding Bracket to Fence Mounting Bracket)5 - Flat Washer (f

8Fig. 5Fig. 6Fig. 7Fig. 82. Assemble the fence sliding bracket (C) Fig. 7, tomounting bracket (A) using the lockhandle (D), flatwasher (E) and special

99Fig. 9Fig. 10Fig. 11Fig. 126. Tighten two screws (G) Fig. 12.5. Position fence (L) Fig. 11, so that rounded section(M) on bottom of fence is over cu