Delta 4000 Manual de instrucciones descargar pdf (Pagina 38)

81331 Rev 01 Nov 2010

uto Tip-up Test Tip-up testing is used for testing power

components with voltage dependent dissipation

factor (e.g. generators) or in case a voltage

dependence is suspected and indicated by high

DF in Delta4000. The highest voltage level

used is set on main page and the voltage per

step is set on the settings page Voltage steps

can be set on the settings page

Frequency Sweep Frequency Sweep allows the user to perform a

series of tests over a frequency range. The

oltage level used is set on main page and the

oltage per step is set on the settings page. Note

that there are limitation of voltage levels at high

frequencies and low frequencies below 45 Hz

Manual

his mode allows continuous manual control of

output voltage.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 107 108

Sin comentarios

Delta 4000 Manual de instrucciones Pagina 38