Delta 46-715 El manual del propietario Pagina 1

OWNER’S MANUAL RING MASTER® For the DELTA 46-715 14" Wood Lathe Cat. No. 744 CAUTION - Read important safety

10 70166 70140, 70141 70138 70130 MAINTENANCE Keep your RING MASTER® clean. If compressed air is available, blow each part clean after us

11 11234567389101815141837363533172920272830323431121611251919242126232213

12 Item No. Part No. QtPart Description 1 301070 3 Nyloc Hex Nut ¼-20 2 301443 1 Swing Frame Lock Screw 3 301422 5 Socket Cap Screw 10-32

13 NOTES PO Box 1257, Wilmington, NC 28402 910-762-6334 * 800-634-9281 * FAX: 910-763-8650 www.ringm

2 RING MASTER® - DELTA 46-715 14” CAT. NO. 744 OPERATING INSTRUCTIONS PNI’s LIMITED ONE YEAR WARRANTY PNI is proud of the RING MASTER® it ma

3 General Safety Instructions for Power Tools 1. KNOW YOUR POWER TOOL Read the owner's manual carefully. Learn its applications and limit

4 Assembly 1. Locate index plate (Item A), (1) #10-32 screw 5/8" long, with washer (Items B) and attach index plate to right end of "

5 MOUNTING THE WOOD ON THE DELTA 46-715 14" LATHE Attach the arbor, provided, to the DELTA 46-715 Lathe. Mount the wood on the arbor and place

6 INSTALL AND ALIGN THE CUTTING TOOL The cutting tool consists of two blades, a left and a right hand blade. Install blades in proper left and rig

7 FIGURE 5 CUTTING SPEED You may vary the R.P.M. depending on the diameter of the ring. Cut the largest 10-11" dia. rings at slow (700

8 CHANGING THE CUTTING ANGLE TO 90 DEGREES After you have cut a number of angle rings, you will want to cut some straight or 90 degree rings whose

9 some glue is squeezed out from between the rings. Use a damp cloth to remove any excess glue. Then loosen the clamp, check to see that the rings a