Delta JT360 Manual de usuario descargar pdf (Pagina 15)

15 - English

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING JOINTER

1. The on/off switch (A) Fig. 33 is located on the front of the jointer. To turn the machine "ON", move switch (A) up

to the "ON" position.

2. To turn the machine "OFF", move the switch down to the "OFF" position.

Make sure that the switch is in the "OFF" position before plugging in the power cord. In the

event of a power failure, move the switch to the "OFF" position. An accidental start-up can cause injury.

LOCKING SWITCH IN THE "OFF" POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the "OFF" position to prevent

unauthorized use. To lock the switch, grasp the switch toggle (A) Fig. 33 and pull it out of the switch. With the switch

toggle (B) Fig. 34 removed, the switch will not operate. However, should the switch toggle be removed while the saw

is running, the machine can be turned "OFF," but cannot be restarted without re-inserting the switch toggle (B).

INFEED TABLE ADJUSTMENTS

1. To raise or lower the infeed table, loosen table

lockhandle (A) Fig. 35, move the table raising and

lowering handle (B) up or down until the table is at

the desired position and tighten table lockhandle (A).

Fig. 35

Fig. 24

Fig. 33 Fig. 34

3. Replace set screw (A) Fig. 24, which was removed in

STEP 1.

4. Fig. 24, illustrates the cutterhead guard (C) as sem-

bled to the infeed table.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Sin comentarios

Delta JT360 Manual de usuario Pagina 15