Delta AP300 Manual de usuario descargar pdf (Pagina 14)

STARTING AND STOPPING

DUST COLLECTOR

1. The on/off switch (A) Fig. 24 is located on the front

of the machine. To turn the machine “ON”, move the

switch up to the “ON” position.

2. To turn the machine “OFF”, move the switch (A)

down to the “OFF” position.

MAKE SURE THAT THE SWITCH IS IN

THE “OFF” POSITION BEFORE

PLUGGING IN THE POWER CORD. IN THE EVENT OF A

POWER FAILURE, MOVE THE SWITCH TO THE “OFF”

POSITION. AN ACCIDENTAL START-UP CAN CAUSE

INJURY.

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the “OFF” position to

prevent unauthorized use. To lock the machine, grasp

the switch toggle (B) Fig. 25, and pulling it out of the

switch as shown. With the switch toggle (B) removed,

the switch will not operate. However, should the switch

toggle be removed while the machine is running, it can

be turned “OFF” once, but cannot be restarted without

re-inserting the switch toggle (B).

Fig. 24

Fig. 25

OPERATION

For operator safety, make certain the dust intake port is covered with the hose before operating the machine.

The rotating fan inside the blower housing is accessible through the dust intake port and is hazardous. Make sure intake cap

covers the intake port when hose is removed. Always wear proper apparel. Do not wear jewelry and keep fingers and all foreign

objects out of the dust intake port. Always follow the safety rules of this manual.

OPERATIONAL CONTROLS AND ADJUSTMENTS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sin comentarios

Delta AP300 Manual de usuario Pagina 14